Diagnostic trouble code P0088 4GR-FSE Engine

Description

Wiring diagram

Inspection procedure

CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0088)

CHECK FUEL PRESSURE SENSOR

REPLACE FUEL PUMP (HIGH PRESSURE SIDE)

CHECK IF DTC OUTPUT REOCCURS (SEE IF DTC P0088 IS OUTPUT AGAIN)

DTC P0088 Fuel Rail / System Pressure - Too High

Description

Refer to DTC P0087 .  

DTC No. DTC Detection Condition Trouble Area
P0088 ECM did not command that the high pressure side fuel pump opens spill valve, but fuel pressure increases 3 MPa (30.6 kgf/cm2, 435 psi) for more than 10 seconds
  1. High pressure side fuel pump
  2. Fuel pressure sensor
  3. ECM

Wiring diagram

Refer to DTC P0190 .

Inspection procedure

HINT:

Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred .

 

1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0088)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear DTCs.

  1. Start the engine.

  1. Enter the following menus: Power train / Engine / DTC.

  1. Read the DTCs using the intelligent tester.

    Result:

    Display (DTC output) Proceed to
    P0088 A
    P0088 and other DTCs B

HINT:

If any other codes besides P0088 are output, perform troubleshooting for those DTCs first.

  B  
GO TO DTC CHART
 
A  
   

2.CHECK FUEL PRESSURE SENSOR

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Start the engine.

  1. Turn the tester ON.

  1. Enter the following menus: Power train / Engine / Data List / Fuel Press.

  1. Check that the fuel pressure fluctuates when the engine is raced.

    OK:

    Fuel pressure fluctuates.

  NG  
REPLACE FUEL PRESSURE SENSOR
 
OK  
   

3.REPLACE FUEL PUMP (HIGH PRESSURE SIDE)
NEXT  
   

4.CHECK IF DTC OUTPUT REOCCURS (SEE IF DTC P0088 IS OUTPUT AGAIN)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and turn the tester ON.

  1. Clear DTCs.

  1. Start the engine.

  1. Enter the following menus: Power train / Engine / DTC.

  1. Read the DTCs using the intelligent tester.

    Result:

    Display (DTC output) Proceed to
    P0088 A
    No output B
  B  
SYSTEM IS OK
 
A  
   
REPLACE ECM