MILLIMETER WAVE RADAR SENSOR - REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation .

2. REMOVE COOL AIR INTAKE DUCT SEAL

Using a clip remover, remove the 11 clips and cool air intake duct seal.

3. REMOVE FRONT BUMPER ASSEMBLY

Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

Tape the screwdriver tip before use.

Use the same procedures for the RH side and LH side.

Put protective tape around the front bumper assembly.

Using a clip remover, remove the 2 clips

Remove the 2 radiator grille protectors.

Remove the bolt and 10 screws.

Disengage the 5 claws and disconnect the front bumper assembly as shown in the illustration.

Disconnect the headlight washer hose. (w/ headlight cleaner system)

Disconnect the connector and remove the front bumper assembly.

4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

Disconnect the connector.

Remove the 3 bolts and the millimeter wave radar sensor assembly.

Millimeter Wave Radar Sensor - Removal