Lexus IS250 IS220d GSE20 ALE20 - CAN COMMUNICATION
CHECK WIRE HARNESS (+B1, +B, E)
CAN COMMUNICATION SYSTEM (for LHD) - ECM Communication Stop Mode
DESCRIPTION
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | "Engine" and "ECT" are not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "ECM Communication Stop Mode" in the "DTC COMBINATION TABLE" |
Power source circuit of the ECM ECM |
- HINT:
- "Engine" and "ECT" refer to the circuit that includes the ECM.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK WIRE HARNESS (+B1, +B, E) |
Turn the engine switch off.
Disconnect the ECM connectors (E4) and (A5).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Condition Specified Value E4-7 (E1) - Body ground Always Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Value A5-5 (+B1) - Body ground Engine switch off 10 to 14 V A5-6 (+B) - Body ground Engine switch off 10 to 14 V
|
| ||||
| OK | ||
| ||
LEXUS IS250, IS220d / GSE20 ALE20