2Ad-Fhv Can Communication System (For Rhd) - How To Proceed With Troubleshooting

Lexus IS250 IS220d GSE20 ALE20 - CAN COMMUNICATION


2AD-FHV CAN COMMUNICATION SYSTEM (for RHD) - HOW TO PROCEED WITH TROUBLESHOOTING

  • NOTICE:
DTCs for the CAN communication system are as follows: U0073, U0105, U0155, U0121, U0124, 5C-42.
Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.

1.CHECK CAN BUS LINE

Check the CAN bus lines .

NEXT
2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION)

Check if the vehicle is equipped with any of the following: vehicle dynamics integrated management (VDIM) and parking assist monitor systems.

NEXT
3.CHECK AND CLEAR DTCS
  • HINT:
CAN communication DTCs are output when there is an open or short in any of the communication lines. Any problems with the power source of a corresponding ECU or sensor, or problems in the ECU or the sensor itself also cause these DTCs to be output.
If a CAN communication line connector is disconnected with the engine switch on (IG), the ECUs of the corresponding system and related systems record a DTC.
NEXT
4.CHECK ECUS AND SENSORS WITH INTELLIGENT TESTER

Using the intelligent tester, display the "Communication Bus Check" screen .

Observe the screen for approximately 1 minute to check the ECUs and sensors displayed on the screen.

  • Result:
  • SymptomProceed toSee Procedure
    All ECUs and sensors connected to the CAN communication system are displayed on the screen.AGo to step 5
    Some of the ECUs and sensors connected to the CAN communication system are not displayed on the screen.B
    Some of the ECUs and sensors connected to the CAN communication system are not displayed on the screen. During this check, some ECUs and sensors repeatedly appear and disappear from the screen.C
  • NOTICE:
The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and optional equipment. Check which systems (ECUs, sensors) are installed on the vehicle .
Non-installed ECUs or sensors will not be displayed. Do not mistake them for being in the communication stop mode.
The ECUs and sensors that repeatedly appear and disappear from the screen during this check are considered normal. (The response to the intelligent tester and the tester display are affected by signals output from other ECUs which have an open circuit in either of their CAN branch lines.)
B.
COMMUNICATION STOP MODE TABLE
C.
GO TO "OPEN IN ONE SIDE OF CAN BRANCH LINE"
A
5.DTC COMBINATION TABLE

Confirm trouble according to the combination of output DTCs regarding the CAN communication system .

  • HINT:
  • Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester's "Communication Bus Check" screen.
NEXT
6.CIRCUIT INSPECTION
NEXT
7.IDENTIFICATION OF PROBLEM
NEXT
8.REPAIR OR REPLACE
NEXT
9.CONFIRMATION TEST
NEXT
END