Lexus IS250 IS220d GSE20 ALE20 - CAN COMMUNICATION
CHECK CAN BUS LINE FOR OPEN (STEERING ANGLE SENSOR BRANCH LINE)
2AD-FHV CAN COMMUNICATION SYSTEM (for LHD) - Steering Angle Sensor Communication Stop Mode
DESCRIPTION
| Detection Item | Symptom | Trouble Area |
| Steering Angle Sensor Communication Stop Mode | "Steering Angle Sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Steering Angle Sensor Communication Stop Mode" in the "DTC COMBINATION TABLE" |
Power source circuit of the steering angle sensor Steering angle sensor branch line or connector Steering angle sensor |
- HINT:
- "Steering Angle Sensor" refers to the circuit that includes the steering angle sensor.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.CHECK CAN BUS LINE FOR OPEN (STEERING ANGLE SENSOR BRANCH LINE) |
Turn the engine switch off.
Disconnect the steering angle sensor connector (J23).
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Condition Specified Value J23-10 (CANH) - J23-9 (CANL) Engine switch off 54 to 69 Ω
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (IG, ESS) |
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection Condition Specified Value J23-2 (ESS) - Body ground Always Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Value J23-1 (IG) - Body ground Engine switch on (IG) 10 to 14 V
|
| ||||
| OK | ||
| ||
LEXUS IS250, IS220d / GSE20 ALE20