VEHICLE STABILITY CONTROL SYSTEM (w/o VDIM) - ABS Warning Light does not Come ON

Check if the CAN communication system DTC is output ( for LHD, or for RHD).

• Result:

• Condition	Proceed to
  DTC is not output	A
  DTC is output	B

Check if the multiplex communication system DTC is output .

• Result:

• Condition	Proceed to
  DTC is not output	A
  DTC is output	B

Disconnect the skid control ECU connector.

Turn the engine switch on (IG).

Check that the ABS warning light comes on.

• OK:
• ABS warning light comes on.

• HINT:

• If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part .

Turn the engine switch off.

Reconnect the skid control ECU connector.

Perform Active Test of the combination meter (meter CPU) using the intelligent tester .

• OK:
• The ABS warning light turns on or off in accordance with the intelligent tester.

• HINT:

• If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step .