Lexus IS250 IS220d GSE20 ALE20 - BRAKE
REAR BRAKE - REMOVAL
- HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
| 1. REMOVE REAR WHEEL |
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- If brake fluid leaks onto any painted surface, wash off or remove the brake fluid completely.
| 3. REMOVE REAR DISC BRAKE PAD WITH ANTI-SQUEAL SHIMS |
Remove the pin hold clip and disengage the engaged parts of anti-squeal spring.
Remove the 2 pad guide pins and anti-squeal spring.
Remove the 2 brake pads with the anti-squeal shims.
| 4. REMOVE ANTI-SQUEAL SHIM |
Remove the 4 anti-squeal shims from each pad.
| 5. DISCONNECT REAR FLEXIBLE HOSE LH |
Remove the union bolt and gasket from the rear disc brake cylinder assembly, then disconnect the flexible hose.
| 6. REMOVE NO. 1 REAR DISC BRAKE CYLINDER SUPPORT PIN |
Remove the No. 1 cylinder support pin and tilt the disc brake cylinder assembly toward the rear of the vehicle.
| 7. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY |
Remove the 2 bolts and cylinder assembly rear together with the caliper support bracket.
Remove the 2 No. 1 caliper plates from the caliper support bracket.