DTC C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone

DTC C1336/39 Zero Point Calibration of Acceleration Sensor Undone

DESCRIPTION

The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system.

The yaw rate sensor has the built in acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If there is trouble in the bus lines between the yaw rate and acceleration sensor and the CAN communication system, the DTCs U0123/62 (yaw rate sensor communication trouble) and U0124/95 (acceleration sensor communication trouble) are output.

The DTCs are also output when the calibration has not been completed.

DTC No.	DTC Detection Condition	Trouble Area
C1210/36	Zero point calibration of yaw rate sensor undone.	Brake actuator assembly (Skid control ECU) Yaw rate and acceleration sensor Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal)
C1336/39	When either of the following is detected: The vehicle runs in the normal mode with zero point calibration undone. After the zero point has been obtained, the zero point voltage of the sensor is not between 2.38 and 2.62 V.	Brake actuator assembly (Skid control ECU) Yaw rate and acceleration sensor Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal)

INSPECTION PROCEDURE

NOTICE:

When replacing the brake actuator assembly, perform zero point calibration .

HINT:

When U0123/62, U0124/95 or U0126/63 is output along with C1210/36 or C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/95 or U0126/63 first.

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR

Perform zero point calibration of the yaw rate and acceleration sensor .

NEXT

2.RECONFIRM DTC

Clear the DTC .

Check if the same DTCs are recorded .

Result:
Condition Proceed to
DTCs (C1210/36 and/or C1336/39) are output A
DTCs (C1210/36 and/or C1336/39) are not output B

HINT:

The DTCs are recorded because zero point calibration has not been completed.

End the procedure since the same DTCs are not recorded after completion of zero point calibration.

B

USE SIMULATION METHOD TO CHECK

A

3.CHECK YAW RATE AND ACCELERATION SENSOR INSTALLATION

Turn the engine switch off.

Check that the yaw rate and acceleration sensor has been installed properly .

OK:
The sensor should be tightened to the specified torque.
The sensor should not be tilted.

NG

INSTALL YAW RATE AND ACCELERATION SENSOR CORRECTLY

OK

REPLACE BRAKE ACTUATOR ASSEMBLY

LEXUS IS250, IS220d / GSE20 ALE20

BRAKE CONTROL

Lexus IS250 IS220d GSE20 ALE20

VEHICLE STABILITY CONTROL SYSTEM w/o VDIM