INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

ADJUST FULLY CLOSED POSITION

INSTALL SUNSHADE TRIM SUB-ASSEMBLY

INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

Hold down the window deflector.

• NOTICE:

• Make sure that the spring indicated by the arrow in the illustration is securely installed.

Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

Engage the 2 claws and install the sliding roof drip channel.

Install the 2 sliding roof side stoppers with the 2 screws.

• Torque:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.

• HINT:

• Tape the screwdriver tip before use.

Insert the sunshade trim into the sliding roof housing sub-assembly.

Install the sliding roof piece sub-assemblies LH and RH with the 2 screws.

• Torque:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Install the sliding roof drive gear sub-assembly with the 2 bolts.

• Torque:
• 5.4 N*m{ 55 kgf*cm, 48 in.*lbf}

Engage the claw and install the sliding roof drive gear bracket.