Roof Drip Side Finish Moulding - Installation

Lexus IS250 IS220d GSE20 ALE20 - EXTERIOR

ROOF DRIP SIDE FINISH MOULDING - INSTALLATION

1. INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP
  • NOTICE:
If reusing the clips, do not remove the double-sided tape remaining on the clips and where the clips will be installed on the body.
If installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue type solvent.
Roof Drip Side Finish Moulding - Installation. EXTERIOR. Lexus IS250 IS220d GSE20 ALE20

Apply a 2 to 3 mm (0.07 to 0.11 in.) bead of adhesive (3M DP-105 or equivalent) from the tube to new No. 1 roof drip side finish moulding clips.

  • HINT:
  • Adhesive strength (tensile strength): 13.7 MPa (140 kgf/cm2) or more (when the temperature is 23°C)

Press and install the No. 1 roof drip side finish moulding clips.

Install the clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the No. 1 roof drip side finish moulding clips after lightly rubbing up adhesive (3M DP-105 or equivalent) .

Install the roof drip side finish moulding center when 20 minutes or more have elapsed after pressing and installing the No. 1 roof drip side finish moulding clips.

  • HINT:
Initial hardening time 20 minutes
Complete hardening time 48 hours

Roof Drip Side Finish Moulding - Installation. EXTERIOR. Lexus IS250 IS220d GSE20 ALE20

2. INSTALL ROOF DRIP SIDE FINISH MOULDING CENTER
3. INSTALL NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP
4. INSTALL ROOF DRIP SIDE FINISH MOULDING