POWER WINDOW CONTROL SYSTEM - Rear Power Window Motor RH Circuit

Remove the power window motor.

Apply battery voltage to the motor connector according to the table below.

• NOTICE:

• Do not apply battery voltage to any terminals except terminals 1 and 2.

• Standard:

• Measurement Condition	Specified Condition
  Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates clockwise
  Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates counterclockwise

Disconnect the N1 and N7 connectors.

Measure the resistance according to the value(s) in the table below.

• Resistance:

• Tester Connection	Condition	Specified Condition
  N1-1 (DN) - N7-1 (D)	Always	Below 1 Ω
  N1-6 (UP) - N7-2 (U)	Always	Below 1 Ω
  N1-1 (DN) - Body ground	Always	10 kΩ or higher
  N1-6 (UP) - Body ground	Always	10 kΩ or higher