Power Window Control System - Rear Power Window Motor Lh Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT POWER WINDOW REGULATOR MOTOR
CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK SWITCH)
POWER WINDOW CONTROL SYSTEM - Rear Power Window Motor LH Circuit
DESCRIPTION
This circuit transmits signals from the multiplex network switch to the power window regulator motor.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT POWER WINDOW REGULATOR MOTOR |
Remove the power window motor.
Apply battery voltage to the motor connector according to the table below.
- Do not apply battery voltage to any terminals except terminals 1 and 2.
- Standard:
| Measurement Condition | Specified Condition |
Battery positive (+) → Terminal 1 (D)
Battery negative (-) → Terminal 2 (U) | Motor gear rotates clockwise |
Battery positive (+) → Terminal 2 (U)
Battery negative (-) → Terminal 1 (D) | Motor gear rotates counterclockwise |
| | REPLACE POWER WINDOW REGULATOR MOTOR |
|
|
| 2.CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - MULTIPLEX NETWORK SWITCH) |
Disconnect the O1 and O7connectors.
Measure the resistance according to the value(s) in the table below.
- Resistance:
| Tester Connection | Condition | Specified Condition |
| O1-1 (DN) - O7-1 (D) | Always | Below 1 Ω |
| O1-6 (UP) - O7-2 (U) | Always | Below 1 Ω |
| O1-1 (DN) - Body ground | Always | 10 kΩ or higher |
| O1-6 (UP) - Body ground | Always | 10 kΩ or higher |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK | |
| |
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
LEXUS IS250, IS220d / GSE20 ALE20
