DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK RAIN SENSOR
CHECK HARNESS AND CONNECTOR (RAIN SENSOR - OVERHEAD J/B)
WIPER AND WASHER SYSTEM - Rain Sensor Circuit
DESCRIPTION
This circuit provides power to operate the rain sensor.
The auto wiper system operates when the windshield wiper switch assembly is in the AUTO position.
The rain sensor is connected to other ECUs through the multiplex communication line (BEAN).
When the rain sensor detects raindrops in the detection area on the windshield glass, the sensor sends a wiper control signal according to the amount of raindrops to the main body ECU LH (cowl side J/B LH).
The rain sensor also sends signals to the adaptive radar cruise control system and the mirror defogger system.
WIRING DIAGRAM
INSPECTION PROCEDURE
Before starting the following procedure, check that multiplex communication system (MPX) DTCs are not output .
Before starting the following procedure, verify that the rain sensor tape is correctly installed.
Disconnect the R7 rain sensor connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
| Tester Connection | Condition | Specified Condition |
| R7-1 (SIG) - R7-3 (ES) | Engine switch on (IG) | 10 to 14 V |
| Engine switch off | Below 1 V |
| | PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
| OK | |
| |
| CHECK HARNESS AND CONNECTOR (RAIN SENSOR - OVERHEAD J/B) |
|
| 2.CHECK HARNESS AND CONNECTOR (RAIN SENSOR - OVERHEAD J/B) |
Disconnect the R5 overhead J/B connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
| Tester Connection | Condition | Specified Condition |
| R5-21 (IG) - R5-40 (GND2) | Engine switch on (IG) | 10 to 14 V |
| Engine switch off | Below 1 V |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR (OVERHEAD J/B - BATTERY) |
|
|
| OK | |
| |
| REPAIR OR REPLACE HARNESS OR CONNECTOR (RAIN SENSOR - OVERHEAD J/B) |
|
LEXUS IS250, IS220d / GSE20 ALE20
