INSPECT SCUFF PLATE LIGHT

Disconnect the connector from the scuff plate light.

Measure the voltage according to the value(s) in the table below.

• Standard voltage:

• LH Side:

  Tester Connection	Condition	Specified Condition
  Q8-2 (+) - Q8-1 (-)	Any door is opened	10 to 14 V
  Q8-2 (+) - Q8-1 (-)	All doors are closed	Below 1 V

• RH Side:

  Tester Connection	Condition	Specified Condition
  P2-2 (+) - P2-1 (-)	Any door is opened	10 to 14 V
  P2-2 (+) - P2-1 (-)	All doors are closed	Below 1 V

If the result is not as specified, repair or replace the wire harness or connector.

Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

Check that the scuff plate light comes on.

• OK:
• Comes on

If the result is not as specified, replace the scuff plate.