REGISTER ILLUMINATION - INSPECTION

1. INSPECT REGISTER ILLUMINATION (LH Side)

Disconnect the connector from the register.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Condition Specified Condition
J11-2 (ILL+) - Body ground Dimmer switch ON 10 to 14 V
J11-2 (ILL+) - Body ground Dimmer switch OFF Below 1 V

If the result is not as specified, repair or replace the wire harness or connector.

Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

Check that the register illumination comes on.

If the result is not as specified, replace the register illumination.

2. INSPECT REGISTER ILLUMINATION (RH Side)

Disconnect the connector from the register.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
Tester Connection Condition Specified Condition
J73-2 (ILL+) - Body ground Dimmer switch ON 10 to 14 V
J73-2 (ILL+) - Body ground Dimmer switch OFF Below 1 V

If the result is not as specified, repair or replace the wire harness or connector.

Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.

Check that the register illumination comes on.

If the result is not as specified, replace the register illumination.

3. INSPECT REGISTER ILLUMINATION (Center)

Disconnect the connector from the register.

Measure the voltage according to the value(s) in the table below.

Standard voltage:
LH Side:
Tester Connection Condition Specified Condition
J33-2 (ILL+) - Body ground Dimmer switch ON 10 to 14 V
J33-2 (ILL+) - Body ground Dimmer switch OFF Below 1 V
RH Side:
Tester Connection Condition Specified Condition
J32-2 (ILL+) - Body ground Dimmer switch ON 10 to 14 V
J32-2 (ILL+) - Body ground Dimmer switch OFF Below 1 V

If the result is not as specified, repair or replace the wire harness or connector.

Connect the (+) lead from the battery to terminal 2 and the (-) lead to terminal 1.