Lexus IS250 IS220d GSE20 ALE20 - DOOR LOCK
REAR DOOR LOCK - REMOVAL
| 1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG |
Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
| 2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY |
Using a screwdriver wrapped with protective tape, disengage the 2 claws and 2 clips.
Disconnect the connector and remove the rear power window regulator switch assembly.
| 3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
Remove the 2 screws.
Using the clip remover, disengage the 8 clips.
Pull out the rear door trim board in the direction indicated by the arrow.
Remove the reference bosses from the rear door panel.
Raise the rear door trim board to disengage the 3 claws and remove the rear door trim board together with the rear door inner glass weatherstrip.
Disconnect the cables and each connector from the back side of the inside handle and the rear door trim board sub-assembly, remove the rear door trim board sub-assembly.
Remove the 2 rear door trim board retainers (green) from the rear door trim board.
| 4. REMOVE REAR DOOR TRIM COVER |
Remove the screw.
Using a clip remover, detach the 5 clips and remove the rear door trim cover.
| 5. REMOVE REAR DOOR SERVICE HOLE COVER |
Disconnect the connector and 2 clamps.
Remove the rear door service hole cover.
- HINT:
- Remove the remaining tape on the door side.
| 6. REMOVE REAR DOOR GLASS RUN |
Remove the rear door glass run.
| 7. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
Remove the 2 bolts, the screw, and the rear door window division bar sub-assembly.
| 8. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
- NOTICE:
- Do not damage the door glass.
| 9. REMOVE REAR DOOR LOCK ASSEMBLY |
Using a "torx" socket wrench (T30), remove the 3 screws and the rear door lock assembly.
Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.
Remove the door lock wiring harness seal from the rear door lock assembly.
Using a screwdriver, disengage the claw.
Remove the rear door lock remote control cable assembly.
Using a screwdriver, disengage the 3 claws.
Remove the rear door inside locking cable assembly.