INSTALL NAVIGATION ECU

INSTALL MULTI-DISPLAY ASSEMBLY

INSTALL NO. 2 RADIO BRACKET

INSTALL NO. 1 RADIO BRACKET

INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY

INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL

INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

INSTALL CONSOLE BOX

INSTALL CONSOLE BOX REGISTER ASSEMBLY

INSTALL FRONT ASH RECEPTACLE SUB-ASSEMBLY

INSTALL FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)

INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission)

INSTALL CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission)

INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission)

INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission)

INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)

INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)

INSERT MAP DISC

ADJUST CLOCK

Install the navigation ECU with the 4 bolts.

Connect the connectors.

Install the radio No. 2 bracket with the 7 bolts.

Install the radio No. 1 bracket with the 7 bolts.

Engage the connector clamp.

Connect each connector.

Install the the multi-display w/ radio receiver assembly with the 4 bolts.

Engage the 4 claws and install the center lower instrument cluster finish panel.

Connect the connectors.

Engage the 11 claws and install the No. 3 instrument panel register assembly.

Engage the 2 claws and 2 clips.

Install the 2 bolts <C-.

Install the 2 bolts <C-.

Connect the connector.

Connect the connectors.

Engage the 2 clamps.

Install the 2 bolts <C-.

Engage the 2 claws and 4 clips, and then install the console box register assembly.

Install the rear ash receptacle assembly.

Connect the connectors.

Insert the protruding parts of the front ash receptacle sub-assembly into the 2 guide holes as shown in the illustration.

Install the front ash receptacle sub-assembly with the 2 screws <F-.

Engage the 6 clips.

Close the snap.

Engage the 7 claws and 2 clips.

Close the snap.

Connect the connectors.

Engage the 8 clips and install the console panel sub-assembly.

Engage the claw and 2 clips, and then install the upper No. 2 console panel garnish.

Engage the claw and 2 clips, and then install the upper No. 1 console panel garnish.

Remove the clock assembly

Turn the engine switch on (ACC).

Insert the map disc.

Check that the wire harness is in the position shown in the illustration.

Install the clock assembly.