DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT SATELLITE SWITCH
CHECK HARNESS AND CONNECTOR (COMBINATION METER - SATELLITE SWITCH)
METER / GAUGE SYSTEM - Satellite Switch Circuit
DESCRIPTION
The meter CPU receives satellite switch signals from the satellite switch in this circuit.
The meter CPU sends satellite switch signals to the AFS ECU and clearance sonar ECU using the BEAN lines. Each ECU controls every system based on these signals.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT SATELLITE SWITCH |
Disconnect the connector from the satellite switch.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
| Tester Connection | Condition | Specified Condition |
| J16-2 (LSET) - J16-5 (E) | Satellite switch LH is pressed | Below 1 Ω |
| J16-2 (LSET) - J16-5 (E) | Satellite switch LH is not pressed | 10 kΩ or higher |
| J16-3 (SET) - J16-5 (E) | Satellite switch ON/OFF is pressed | Below 1 Ω |
| J16-3 (SET) - J16-5 (E) | Satellite switch ON/OFF is not pressed | 10 kΩ or higher |
| J16-4 (RSET) - J16-5 (E) | Satellite switch RH is pressed | Below 1 Ω |
| J16-4 (RSET) - J16-5 (E) | Satellite switch RH is not pressed | Below 1 Ω |
| 2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - SATELLITE SWITCH) |
Disconnect the J35 and J16 connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
| Tester Connection | Condition | Specified Condition |
| J35-5 (RSEL) - J16-4 (RSET) | Always | Below 1 Ω |
| J35-6 (LSEL) - J16-2 (LSET) | Always | Below 1 Ω |
| J35-7 (SEL) - J16-3 (SET) | Always | Below 1 Ω |
| J16-2 (LSET) - Body ground | Always | 10 kΩ or higher |
| J16-3 (SET) - Body ground | Always | 10 kΩ or higher |
| J16-4 (RSET) - Body ground | Always | 10 kΩ or higher |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK | |
| |
| REPLACE COMBINATION METER ASSEMBLY |
|
LEXUS IS250, IS220d / GSE20 ALE20
