HIGH INTENSITY DISCHARGE HEADLIGHT BULB - REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL

Using a clip remover, remove the 11 clips and cool air intake duct seal.

3. REMOVE ENGINE ROOM SIDE COVER (for 4GR-FSE)

Using a clip remover, remove the 4 clips.

Disengage the nut and remove the engine room side cover.

4. REMOVE ENGINE ROOM SIDE COVER (for 2AD-FHV)

Using a clip remover, remove the 3 clips.

Disengage the nut and remove the engine room side cover.

5. REMOVE WASHER HOSE

Remove the bolt and washer hose.

6. REMOVE DISCHARGE HEADLIGHT BULB

Remove the headlight socket cover as shown in the illustration.

Remove the headlight gasket.

After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.

Separate the light control ECU socket as shown in the illustration.

Release the set spring and remove the discharge headlight bulb as shown in the illustration.

After the discharge headlight bulb is replaced, make sure that it comes on. Then, reinstall all the parts that were removed to replace the bulb.

LEXUS IS250, IS220d / GSE20 ALE20