INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY

INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

INSTALL STEERING COLUMN COVER (for Manual Tilt and Telescopic)

INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic)

INSTALL STEERING WHEEL ASSEMBLY

INSTALL STEERING PAD

INSTALL NO. 3 LOWER STEERING WHEEL COVER

INSTALL NO. 2 LOWER STEERING WHEEL COVER

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

PERFORM INITIALIZATION

INSPECT SRS WARNING LIGHT

Install the headlight dimmer switch assembly as shown in the illustration.

Install the headlight dimmer switch assembly with the claw and the clamp.

Connect the connector.

Engage the claw and install the windshield wiper switch assembly as shown in the illustration.

Connect the 2 connectors.

Check that the front wheels are facing straight ahead.

Set the turn signal switch to the neutral position.

• NOTICE:

• If it is not in the neutral position, the pin of the turn signal switch may be snapped.

Engage the 3 claws and install the spiral cable with steering sensor.

• NOTICE:

• When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

Connect the connectors to the spiral cable with steering sensor.

• NOTICE:

• When handling the airbag connector, take care not to damage the airbag wire harness.

Engage the claw to install the upper steering column cover.

Engage the 4 clips to install the steering column cover upper onto the instrument panel cluster finish panel.

Engage the 2 claws to install the lower steering column cover.

Install the 2 screws.

• Torque:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Engage the claw to install the steering column cover upper.

Engage the 4 clips to install the steering column cover upper onto the instrument panel cluster finish panel.

Engage the 2 claws to install the steering column cover lower.

• NOTICE:

• Do not damage the tilt and telescopic switch.

Install the 3 screws.

• Torque:
• 2.0 N*m{ 20 kgf*cm, 18 in.*lbf}

Support the steering pad with one hand as shown in the illustration.

Connect the 2 connectors to the steering pad.

• NOTICE:

• When handling the airbag connector, take care not to damage the airbag wire harness.

Connect the horn connector.

Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

• Torque:
• 8.8 N*m{ 90 kgf*cm, 78 in.*lbf}

Install the steering wheel No.3 cover lower.

Install the steering wheel No.2 cover lower.