Lexus IS250 IS220d GSE20 ALE20 - WIPER AND WASHER
FRONT WASHER MOTOR - INSPECTION
| 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY |
- HINT:
- This check should be performed with the front washer motor and pump installed to the washer jar.
Fill the washer jar with washer fluid.
Connect the positive (+) battery lead to terminal 1 of the washer motor and pump, and the negative (-) lead to terminal 2.
Check that washer fluid flows from the washer jar.
- OK:
- Washer fluid is pumped from the washer jar.
| 2. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
- HINT:
- This check should be performed with the headlight cleaner motor and pump installed to the washer jar.
Fill the washer jar with washer fluid.
Connect a positive (+) battery lead to terminal 1 of the headlight cleaner motor and pump, and a negative (-) lead to terminal 2.
Check that washer fluid flows from the washer jar.
- OK:
- Washer fluid is pumped from the washer jar.
| 3. INSPECT HEADLIGHT CLEANER CONTROL RELAY |
Inspect headlight cleaner control relay operation.
Measure the resistance between terminals 4 (E) and 6 (PB).
Connect the positive (+) battery lead to terminal 3 (IG) of the connector, and the negative (-) battery lead to terminal 4 (E).
Connect the negative (-) battery lead to terminal 1 (HOLD) and 2 (H), and measure the resistance between terminals 4 (E) and 6 (PB).
- Standard resistance:
Tester Connection Condition Specified Condition 4 (E) - 6 (PB) Always 10 kΩor higher 4 (E) - 6 (PB) When apply the battery voltage Below 1 Ω 4 (E) - 6 (PB) 0.8 to 0.9 seconds after apply the battery voltage 10 kΩ or higher
Disconnect the negative (-) battery lead from terminal 1 (HOLD) and 2 (H).
Disconnect the positive (+) battery lead from terminal 3 (IG), and then reconnect it.
Connect the negative (-) battery lead to terminals 1 (HOLD) and 5 (FRWA), and measure the resistance between terminals 4 (E) and 6 (PB).
- Standard resistance:
Tester Connection Condition Specified Condition 4 (E) - 6 (PB) When apply the battery voltage Below 1 Ω 4 (E) - 6 (PB) 0.8 to 0.9 seconds after apply the battery voltage 10 kΩ or higher
| 4. INSPECT WASHER FLUID LEVEL SENSOR |
- HINT:
- This check should be performed with the windshield washer motor and pump installed to the washer jar.
Fill the washer jar with washer fluid.
Disconnect the connector from the washer fluid level sensor.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Fluid Volume Specified Condition More than 70 to 900 ml 10 kΩ or higher Less than 700 to 900 ml Below 1 Ω