INSTALL FRONT DOOR LOCK ASSEMBLY

INSTALL FRONT NO. 1 DOOR STIFFENER CUSHION

INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

INSTALL FRONT DOOR OUTSIDE HANDLE COVER

INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

INSTALL FRONT DOOR SERVICE HOLE COVER

INSTALL FRONT DOOR TRIM COVER

INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

INSTALL COURTESY LIGHT ASSEMBLY

INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Install the front door inside locking cable assembly.

Engage the 3 claws.

Install the front door lock remote control cable assembly.

Apply MP grease to the sliding parts on the front door lock assembly.

Install a new door lock wiring harness seal to front door lock assembly.

Insert the front door lock open rod to the front door lock assembly, and set it to the front door outside handle frame.

Make sure that the front door outside handle link is securely connected to the front door lock assembly.

Using a "torx" socket wrench (T30), install the front door lock assembly with the 3 screws.

• Torque:
• 5.5 N*m{ 56 kgf*cm, 49 in.*lbf}

Connect the connector.

Install a new front No. 1 door stiffener cushion with the 2 bolts and double-sided tape.

Apply MP grease to the sliding parts on the front door window regulator sub-assembly.

Install the temporary bolt to the front door window regulator sub-assembly.

Temporarily install the window regulator.

Tighten the 6 bolts in the order shown in the illustration to install the front window regulator.

• Torque:
• 11 N*m{ 112 kgf*cm, 8.1 ft.*lbf}

Connect the connector.

Install the front door lock cylinder.

• HINT:

• Make sure that the front door lock cylinder rod is inserted into the front door lock assembly.

Using a "torx" socket wrench (T30), install the front door lock cylinder with the screw.

Install the hole plug.

Engage the 2 claws of the front door outside handle cover to the front door lock cylinder to install the cover.

Install the front door rear lower frame sub-assembly with the bolt.

Insert the front door glass sub-assembly into the front door panel along the front door glass run as indicated by the arrows in the illustration.

Install the front door glass sub-assembly with the 2 bolts.

• Torque:
• 5.5 N*m{ 56 kgf*cm, 49 in.*lbf}

Install the hole plug.

Apply butyl tape to the front door panel.

Pass the front door lock remote control cable and rear door inside locking cable through a new front door service hole cover.

Install the service hole cover.

• NOTICE:

• Securely install the front door service hole cover avoiding wrinkles and air bubbles.

Connect each connector and each clamp.

Engage the 6 clips to install the front door trim cover.

Install the screw.

Connect the rear door lock remote control cable and rear door inside locking cable to the front inside handle.

Connect each connector.

Engage the front door trim board with the 4 clips of the front door inner glass weatherstrip.

Engage the 9 clips and install the front door trim board to the front door panel.

Install the 2 screws.

Connect the connector.

Engage the claw and install the courtesy light assembly.

Connect each connector.

Engage the 4 claws and 2 clips, and install the power window regulator master switch assembly.

Engage the 3 claws and install the front door inside handle bezel plug.