DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT ENTRY LOCK SWITCH
CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENTRY LOCK SWITCH)
CHECK HARNESS AND CONNECTOR (ELECTRICAL KEY OSCILLATOR - ENTRY LOCK SWITCH)
CHECK AND REPLACE ELECTRICAL KEY OSCILLATOR
ENTRY AND START SYSTEM - Entry Lock Switch Circuit
DESCRIPTION
The entry lock switches (trigger switch) are built into the outside handles of the LH/RH door. The certification ECU detects the conditions of the each lock switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.INSPECT ENTRY LOCK SWITCH |
Remove the outside handle.
Disconnect the connectors.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols) | Condition | Specified Condition |
o1-1 (TRG-) - o1-3 (TRG+) | Lock switch not pushed | 10 kΩ or higher |
Lock switch pushed | Below 1 Ω |
n1-1 (TRG-) - n1-3 (TRG+) | Lock switch not pushed | 10 kΩ or higher |
Lock switch pushed | Below 1 Ω |
| REPLACE OUTSIDE HANDLE ASSEMBLY |
|
|
2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENTRY LOCK SWITCH) |
Disconnect the P33 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols) | Condition | Specified Condition |
P33-3 (TSW1) - o1-3 (TRG+) | Always | Below 1 Ω |
P33-4 (TSW1) - n1-3 (TRG+) | Always | Below 1 Ω |
P33-3 (TSW1) - Body ground | Always | 10 kΩ or higher |
P33-4 (TSW1) - Body ground | Always | 10 kΩ or higher |
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3.CHECK HARNESS AND CONNECTOR (ELECTRICAL KEY OSCILLATOR - ENTRY LOCK SWITCH) |
Disconnect the door oscillator connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection (Symbols) | Condition | Specified condition |
o2-9 (TRG-) - o1-1 (TRG-) | Always | Below 1 Ω |
n2-9 (TRG-) - n1-1 (TRG-) | Always | Below 1 Ω |
o2-9 (TRG-) - Body ground | Always | 10 kΩ or higher |
n2-9 (TRG-) - Body ground | Always | 10 kΩ or higher |
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
4.CHECK AND REPLACE ELECTRICAL KEY OSCILLATOR |
Replace the electrical key oscillator.
Check that the entry LOCK / UNLOCK function operates normally.
- OK:
- Entry LOCK / UNLOCK function operates normally.
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
OK | |
| |
END (ELECTRICAL KEY OSCILLATOR IS DEFECTIVE) |
|
LEXUS IS250, IS220d / GSE20 ALE20