Lexus IS250 IS220d GSE20 ALE20 - DOOR LOCK


ENTRY AND START SYSTEM - DIAGNOSIS SYSTEM

DESCRIPTION

Smart access system with push-button start data and the Diagnostic Trouble Codes (DTCs) can be read in the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.

CHECK DLC3
Entry And Start System - Diagnosis System. DOOR LOCK. Lexus IS250 IS220d GSE20 ALE20

The vehicle uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-03 and matches the ISO 15765-4 format.

Symbols (Terminal No.)Terminal DescriptionConditionSpecified Condition
SIL (7) - SG (5)Bus "+" lineDuring transmissionPulse generation
CG (4) - Body groundChassis groundAlwaysBelow 1 Ω
SG (5) - Body groundSignal groundAlwaysBelow 1 Ω
BAT (16) - Body groundBattery positiveAlways11 to 14 V
CANH (6) - CANL (14)HIGH-level CAN bus lineEngine switch OFF54 to 69 Ω
CANH (6) - Battery positive (+)HIGH-level CAN bus lineEngine switch OFF1 MΩ or higher
CANH (6) - CG (4)HIGH-level CAN bus lineEngine switch OFF1 kΩ or higher
CANL (14) - Battery positive (+)LOW-level CAN bus lineEngine switch OFF1 MΩ or higher
CANL (14) - CG (4)LOW-level CAN bus lineEngine switch OFF1 kΩ or higher
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Entry And Start System - Diagnosis System. DOOR LOCK. Lexus IS250 IS220d GSE20 ALE20

Intelligent Tester

  • HINT:
  • Connect the cable of the intelligent tester to the DLC3, turn the engine switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.