Lexus IS250 IS220d GSE20 ALE20 - DOOR LOCK
ENTRY AND START SYSTEM - CUSTOMIZE PARAMETERS
| CUSTOMIZING FUNCTION WITH INTELLIGENT TESTER |
- HINT:
- The items in the table below can be customized.
- NOTICE:
- HINT:
- The following function's default setting is ON. Part of these functions can be customized.
| Display (Item) | Default | Contents | Setting |
| Park Wait Time (Waiting time to permit opening door after locking) | 3.0s | Function that sets waiting time to permit opening door after door is locked with entry lock function | 1.0s / 2.0s / 3.0s / 5.5s |
| Trunk Open Mode (Luggage compartment door open mode when vehicle is locked) | ON | Function to permit opening luggage compartment door | ON / OFF |
| Key Lo-Batt Wrn (Warn when electrical key battery becomes weak) | ON | Function that warns driver that electrical key's battery power is low (Buzzer in the combination meter, multi-information display) | ON / OFF |
| Door Unlock Mode (Entry door unlock mode) | D-DOOR | Function that makes entry unlock operation available | All / D-DOOR |
| Ignition Area | ALL | Function that switches the entry ignition detection area | FRONT / ALL |
| Warning3 | ON | Function that switches the warning for carrying the electrical key out of the vehicle when the engine switch is on (IG) | ON / OFF |
| Entry Unlock Mode Switching Function |
To change the vehicle to entry unlock mode switching function, make sure the vehicle power is off and simultaneously press and hold the electrical key's LOCK switch and another electrical key switch for 5 seconds.
When the switches are pressed and held for 5 seconds, the entry door unlock mode changes in the following order: driver door mode, one door mode, doors on one side mode, all door mode.
- NOTICE:
- After pressing and holding the switches for 5 seconds, wait 5 seconds before performing the same procedure again.
When the driver door's touch sensor is touched, only the driver door unlocks. When another touch sensor is touched, all doors unlock.
When the touch sensor is touched, all doors unlock.
The certification ECU receives this signal from the entry door control receiver and changes the smart access system with push-button start to the entry unlock mode.
The certification ECU sounds the buzzers of the wireless door lock buzzer and combination meter to inform the user that the mode has been switched.
- HINT:
- The function only changes the entry unlock mode of the entry and start system. It does not switch the unlocking of the wireless door lock control.
| Electrical Key Cancel |
The electrical key cancel operation disables the following functions:
The operation procedures are as follows:
Precondition:
Engine switch off, driver side door closed and unlocked.
Unlock the driver side door once with the UNLOCK switch of the electrical key.
Open the driver door within 5 seconds.
Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
Repeat open → close twice for the driver door within 30 seconds, and open again.
(Driver door: Open → Close → Open → Close → Open)
Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
Repeat open → close once for the driver door within 30 seconds, and open again.
(Driver door: Open → Close → Open)
Close the driver door within 5 seconds.
When electrical key cancel is activated, the wireless door lock buzzer sounds twice.
To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.