DESCRIPTION
INSPECTION PROCEDURE
CHECK FOR DTC OF OTHER COMPONENTS
IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE
CHECK COMPONENT WHICH HAS STORED THIS CODE
CLEAR DTC
RECHECK DTC
DTC 01-DC Transmission Error
DESCRIPTION
DTC No. | DTC Detection Condition | Trouble Area |
01-DC |
Transmission to component shown by sub-code failed. (Detecting this DTC does not always mean actual failure.) |
If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code |
The multi-display is the master unit.
Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.
INSPECTION PROCEDURE
- Be sure to read DESCRIPTION before performing the following procedures.
1.CHECK FOR DTC OF OTHER COMPONENTS |
Check if the component shown by the sub-code is displayed in the check result of the other components.
Check if "01-DC" is output for the other components.
If "01-DC" is output for any other components, check if the same physical address is displayed.
- For the list of the components shown by sub-codes, refer to the table in step 2.
- Result:
Result | Proceed to |
"01-DC" is output and the same physical address is displayed | A |
"01-DC" is not output or the same physical address is not displayed | B |
2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
Component Table:Display | Component |
AUDIO H/U (190) | Radio receiver |
DSP-AMP (440) | Stereo component amplifier |
G/W (1C6) | Gateway ECU |
NAVI (178) | Navigation ECU |
EMV (110) | Multi-display |
CAMERA-C (1AC) | Television camera ECU |
- "NAVI" is the component which has stored this code in the example shown in the illustration.
3.CHECK COMPONENT WHICH HAS STORED THIS CODE |
Select the component which has stored this code.
Component Table:Component | Proceed to |
Gateway ECU (G/W) | Gateway ECU communication error |
Radio receiver (AUDIO H/U) | Radio receiver communication error |
Stereo component amplifier (DSP-AMP) | Stereo component amplifier communication error |
Navigation ECU (NAVI) | Navigation ECU communication error |
Multi-display (EMV) | Multi-display communication error |
Television camera ECU (CAMERA-C) | Television camera ECU communication error |
Clear the DTCs .
- If "01-DC" is output for only one component, this may not indicate a malfunction.
Recheck for DTCs and check if the same trouble occurs again.
- OK:
- Malfunction disappears.
LEXUS IS250, IS220d / GSE20 ALE20