DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
OPERATION OF SPEEDOMETER
INSPECT STEREO COMPONENT AMPLIFIER
CHECK HARNESS AND CONNECTOR (COMBINATION METER - STEREO COMPONENT AMPLIFIER)
CHECK HARNESS AND CONNECTOR (COMBINATION METER - STEREO COMPONENT AMPLIFIER)
AUDIO AND VISUAL SYSTEM - Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION
This circuit is necessary for the ASL (Auto Sound Leveliser) built into the stereo component amplifier. Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable hearing the clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
If a short occurs in an ECU, all systems in the diagram below will not operate normally.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
- OK:
- Actual vehicle speed and the speed indicated on the speedometer are the same.
- The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.
| OK | |
| |
| REPLACE STEREO COMPONENT AMPLIFIER |
|
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - STEREO COMPONENT AMPLIFIER) |
Disconnect the stereo component amplifier connector P30 and combination meter connector J34.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
| Tester connection | Condition | Specified condition |
| SPD - +S | Engine switch off | Below 1 Ω |
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| 4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - STEREO COMPONENT AMPLIFIER) |
Disconnect the stereo component amplifier connector P30 and combination meter connector J34.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
| Tester connection | Condition | Specified condition |
| SPD - Body ground | Engine switch off | 10 kΩ or higher |
- If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU that is connected to the SPD signal wire.
| | REPAIR OR REPLACE HARNESS OR CONNECTOR OR CHECK EACH ECU |
|
|
| OK | |
| |
| REPLACE COMBINATION METER |
|
LEXUS IS250, IS220d / GSE20 ALE20
