AUDIO AND VISUAL SYSTEM - Integration Control and Panel Assembly Power Source Circuit

Disconnect the integration control & panel assembly connector J54.

Measure the resistance according to the value(s) in the table below.

• Standard resistance:

• Tester connection	Condition	Specified condition
  E - Body ground	Always	Below 1 Ω

Measure the voltage according to the value(s) in the table below.

• Standard voltage:

• Tester connection	Condition	Specified condition
  B - GND	Always	10 to 14 V
  ACC - GND	Engine SW on (ACC)	10 to 14 V
  IG+ - GND	Engine SW on (IG)	10 to 14 V