Lexus IS250 IS220d GSE20 ALE20 4GR-FSE STARTING
CHECK OPERATION OF SPEEDOMETER
DTC B2283 Vehicle Speed Sensor Malfunction
DESCRIPTION
The skid control ECU converts these signals into 4-pulse signals and sends them to the combination meter. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the power source control ECU. The power source control ECU determines the vehicle speed based on the frequency of these pulse signals.
- HINT:
- When the power source control ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
| DTC No. | DTC Detection Condition | Trouble Area |
| B2283 | When both conditions below are met: Over-deceleration in vehicle speed Vehicle speed and engine speed do not match |
DTC B2282 detection area Combination meter Speed sensor Skid control ECU Wire harness or connector |
INSPECTION PROCEDURE
| 1.CHECK DTC OUTPUT |
Delete the DTC .
After DTCs are all cleared, turn the engine switch on (IG). After 30 seconds have elapsed, check for DTCs again.
Check for DTC B2282 and DTC B2283.
- OK:
Display (DTC output) Proceed to "DTC B2283" only A "DTC B2283" and "DTC B2282" are output B
- HINT:
- If DTC B2282 and DTC B2283 are output, perform troubleshooting for DTC B2282 first .
|
| ||||
| A | |
| 2.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer in the combination meter is normal.
- OK:
- Actual vehicle speed and the speed indicated on the speedometer are the same.
- HINT:
- The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.
|
| ||||
| OK | ||
| ||
LEXUS IS250, IS220d / GSE20 ALE20