Lexus IS250 IS220d GSE20 ALE20 4GR-FSE FUEL
FUEL PRESSURE PULSATION DAMPER - INSTALLATION
| 1. INSTALL FUEL PRESSURE PULSATION DAMPER |
Using SST, install 2 new gaskets, the fuel tube and pulsation damper to the fuel pump.
- Torque:
- 40 N*m{ 408 kgf*cm, 30 ft.*lbf}
- HINT:
- The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST .
| 2. INSTALL V-BANK COVER SUB-ASSEMBLY |
Engage the 2 clips on the front of the cover, and then engage the clip on the rear to install the V-bank cover.
- NOTICE:
Be sure to engage the clips securely.
Do not apply excessive force or do not hit the cover to engage the clips. This may cause the cover to break.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm, 48 in.*lbf}
| 4. PERFORM INITIALIZATION |
Perform initialization .
- HINT:
- Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.
LEXUS IS250, IS220d / GSE20 ALE20