Lexus IS250 IS220d GSE20 ALE20 4GR-FSE ENGINE MECHANICAL
ENGINE FRONT OIL SEAL - INSTALLATION
| 1. INSTALL TIMING CHAIN CASE OIL SEAL |
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
- SST
- 09223-22010
09506-35010
- NOTICE:
Keep the lip free of foreign matter.
Do not tap the oil seal at an angle.
| 2. INSTALL CRANKSHAFT PULLEY |
Install the pulley set key to the key groove.
Align the pulley set key with the key groove of the pulley, and slide on the pulley.
Using SST, install the crankshaft pulley bolt.
- SST
- 09213-70011(09213-70020)
09330-00021
- Torque:
- 250 N*m{ 2,550 kgf*cm, 184 ft.*lbf}
| 3. INSTALL V-RIBBED BELT |
Install the V-ribbed belt.
While turning the belt tensioner counterclockwise, remove the bar.
- NOTICE:
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
Check that the V-ribbed belt is properly set to each pulley.
If it is difficult to install the V-ribbed belt, perform the following procedure.
Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
- NOTICE:
Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
Check that the V-ribbed belt is properly set to each pulley.
| 4. INSTALL RADIATOR ASSEMBLY |
- HINT:
- .
| 5. CHECK FOR ENGINE OIL LEAKS |
LEXUS IS250, IS220d / GSE20 ALE20