Lexus IS250 IS220d GSE20 ALE20 4GR-FSE ENGINE CONTROL SYSTEM
ECM - INSTALLATION
| 1. INSTALL ECM |
Install the ECM to the ECM box.
- NOTICE:
Install the ECM on the ECM box with the name plate facing the inside of the vehicle.
Make sure that there is no foreign matter on the gasket surface of the ECM box.
Insert the stud bolt on the vehicle rear side to the ECM first.
Make sure that stud bolts are securely installed into the front and rear bolt holes.
Install the 2 nuts.
- Torque:
- 5.5 N*m{ 56 kgf*cm, 49 in.*lbf}
- NOTICE:
- Be sure to first tighten the nut on the vehicle rear.
Connect the ECM connectors.
Connect the 6 ECM connectors.
- NOTICE:
- Be sure to securely connect the connector.
Connect the connector holder to the ECM box.
| 2. INSTALL ECM COVER |
Install the ECM cover with the 3 bolts.
- Torque:
- 5.5 N*m{ 56 kgf*cm, 49 in.*lbf}
- NOTICE:
- Make sure that the wire harness does not get caught between the parts.
| 3. INSTALL ENGINE ROOM SIDE COVER LH |
Install the side cover with the 5 clips.
| 4. INSTALL COOL AIR INTAKE DUCT SEAL |
Install the intake duct seal with the 11 clips.
LEXUS IS250, IS220d / GSE20 ALE20