INSPECT ENGINE SWITCH

Measure the resistance according to the value(s) in the table below.

• Standard resistance:

• Tester Connection	Switch Condition	Specified Condition
  7 (SS1) - 5 (GND)	Pushed	Below 1 Ω
  2 (SS2) - 5 (GND)	Pushed	Below 1 Ω
  7 (SS1) - 5 (GND)	Not pushed	10 kΩ or higher
  2 (SS2) - 5 (GND)	Not pushed	10 kΩ or higher

If the result is not as specified, replace the engine switch.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

• Standard resistance:

• Measurement Condition	Specified Condition
  Battery positive (+) →Terminal 11 (SWIL) Battery negative (-) →Terminal 4 (COM) or 5 (GND)	Illuminates
  Battery positive (+) →Terminal 12 (INDS) Battery negative (-) →Terminal 4 (COM) or 5 (GND)	Illuminates
  Battery positive (+) →Terminal 13 (INDW) Battery negative (-) →Terminal 4 (COM) or 5 (GND)	Illuminates

If the result is not as specified, replace the engine switch.