Lexus IS250 IS220d GSE20 ALE20 2AD-FHV EMISSION CONTROL
AIR FUEL RATIO SENSOR - REMOVAL
| 1. REMOVE FRONT DOOR SCUFF PLATE RH (w/o Illumination)
|
- Use the same procedures for the RH side and the LH side.
| 2. REMOVE FRONT DOOR SCUFF PLATE RH (w/ Illumination) |
| 3. REMOVE REAR DOOR SCUFF PLATE RH |
| 4. REMOVE LAP BELT OUTER ANCHOR COVER
|
Disengage the 3 claws and remove the lap belt outer anchor cover.
| 5. REMOVE LOWER CENTER PILLAR GARNISH RH |
| 6. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
|
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.
- Tape the screwdriver tip before use.
Disconnect the connectors.
Remove the 2 bolts and the front seat outer belt assembly.
| 7. REMOVE CENTER PILLAR GARNISH RH |
| 8. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
| 9. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
| 10. REMOVE FRONT FLOOR COVER RH |
Remove the front floor cover RH.
| 11. REMOVE AIR FUEL RATIO SENSOR |
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor.
LEXUS IS250, IS220d / GSE20 ALE20
