DTC P060B 2ZR-FXE

DTC P060B Internal Control Module A/D Processing Performance

  1. Description

  2. Monitor strategy

  3. Confirmation driving pattern

  4. Inspection procedure

  5. Read output dtc (dtc p060b)

Description

This DTC is output when a communication error occurs in the ECM.

DTC No. DTC Detection Condition Trouble Area
P060B ECM main CPU communication error (1 trip detection logic). ECM

Monitor strategy

Required Sensors/Components (Main) ECM
Frequency of Operation Continuous

Confirmation driving pattern

  1. Turn the power switch off.
  2. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) auxiliary battery terminal.
  4. Turn the power switch on (IG) and wait for 10 seconds or more.

Inspection procedure

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work .

1.READ OUTPUT DTC (DTC P060B)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Clear the DTCs .

  1. Turn the power switch off.

  1. Turn the tester off.

  1. Disconnect the tester.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Connect the tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the tester on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result
    Result Proceed to
    DTC is not output A
    DTC P060B is output B
    DTC P060B and P0327 or P0328 are output C
  B  
REPLACE ECM
 
  C  
GO TO DTC (P0327 AND P0328)
 
A  
   
CHECK FOR INTERMITTENT PROBLEMS