Wireless Charging System Wireless Charger Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER
CRADLE ASSEMBLY - BATTERY AND BODY GROUND)
WIRELESS CHARGING SYSTEM - Wireless Charger Power Source Circuit |
DESCRIPTION
This is the power source circuit to operate the mobile wireless charger cradle assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER
CRADLE ASSEMBLY - BATTERY AND BODY GROUND) |
Disconnect the mobile wireless charger cradle assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E150-1 (PGND) - Body ground
| Always
| Below 1 Ω
|
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
E150-4 (B+) - Body ground
| Power switch off
| 11 to 14 V
|
E150-3 (ACC) - Body ground
| Power switch on (ACC)
| 11 to 14 V
|
Power switch off
| Below 1 V
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here) |
|
