Can Communication System (For Rhd With Central Gateway Ecu) Data List / Active Test

Power Source Network. Land Cruiser. Urj200, 202 Grj200 Vdj200
Networking. Land Cruiser. Urj200, 202 Grj200 Vdj200
  1. DATA LIST

Can Communication System (For Rhd With Central Gateway Ecu) -- Data List / Active Test



DATA LIST
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Central Gateway / Data List.

  5. According to the display on the GTS, read the Data List.

    Central Gateway
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG2 SW
    Ignition switch signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ON
    "OFF" is also displayed for this item when the ignition switch is ACC
    IG1 SW
    Ignition switch signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ON
    "OFF" is also displayed for this item when the ignition switch is ACC
    ACC SW
    Ignition switch signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ACC
    "ON" is also displayed for this item when the ignition switch is ON
    +B Voltage
    Battery voltage / Over 8 V or Under 8 V
    Over 8 V: Battery voltage 8 V or higher
    Under 8 V: Battery voltage below 8 V
    -
    Number of DTC
    The number of the DTC currently stored / Min.: 0, Max.: 255
    0
    -