Dtc C1626 Steering Angle Sensor Failure
DESCRIPTION
INSPECTION PROCEDURE
REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
CHECK DTC OUTPUT
DTC C1626 Steering Angle Sensor Failure |
DESCRIPTION
This DTC is stored if the multi-media module receiver assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.DTC Code
| Detection Item
| DTC Detection Condition
| Trouble Area
|
C1626
| Steering Angle Sensor Failure
| A fail flag is transmitted from the spiral with sensor cable sub-assembly
| - Spiral with sensor cable sub-assembly
- Multi-media module receiver assembly
|
INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point" (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
1.REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY |
Replace the spiral with sensor cable sub-assembly with a new or known good one (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check that no DTCs are output (Click here).
ResultResult
| Proceed to
|
DTC C1626 is not output
| A
|
DTC C1626 is output
| B
|
| REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here) |
|
|
A |
|
|
|
END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE) |
|