Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200
Parking Assist Monitor System -- Problem Symptoms Table |
- NOTICE:
- The following inspection procedures for the parking assist monitor system are based on the assumption that the navigation system*1 or audio and visual system (w/ multi-display)*2 is normal. If the navigation system*1 or audio and visual system (w/ multi-display)*2 has any malfunctions, first proceed with troubleshooting the navigation system*1 or audio and visual system (w/ multi-display)*2.
- *1: w/ Navigation System
- *2: w/o Navigation System
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
| Symptom | Suspected Area | See page |
| When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is not black) | Diagnostic mode - Vehicle signal check mode (w/ Navigation System) | Click here |
| Diagnostic mode - Vehicle signal check mode (w/o Navigation System) | Click here | |
| Multi-media module receiver assembly | Click here | |
| When the shift lever is in R, an image of the area behind the vehicle is not displayed (screen is black) | Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" | Click here |
| When the shift lever is not in R, an image of the area behind the vehicle is displayed | Diagnostic mode - Vehicle signal check mode (w/ Navigation System) | Click here |
| Diagnostic mode - Vehicle signal check mode (w/o Navigation System) | Click here | |
| Multi-media module receiver assembly | Click here | |
| When the shift lever is in R, an image of the area behind the vehicle is displayed and then switches to another image | Diagnostic mode - Vehicle signal check mode (w/ Navigation System) | Click here |
| Diagnostic mode - Vehicle signal check mode (w/o Navigation System) | Click here | |
| Multi-media module receiver assembly | Click here |
| Symptom | Suspected Area | See page |
| Parking assist monitor display malfunction (distortion of the color/ screen) occurs continuously | Proceed to "Image from Camera for Parking Assist Monitor is Abnormal" | Click here |
| Parking assist monitor display malfunction (distortion of the color/ screen) occurs temporarily | Check the usage conditions (explain to the customer that the display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver) | - |
| Guide lines are displayed | Proceed to "Guide Lines are Displayed with Vehicle Center Line" | Click here |
| Symptom | Suspected Area | See page |
| Estimated course lines are not displayed | Parking assist monitor screen display mode settings (check that estimated course line display mode is selected) | - |
| Correct the steering angle neutral point (initialization) | Click here | |
| Steering angle setting (calibration) | Click here | |
| Rear television camera assembly | Click here | |
| Spiral with sensor cable sub-assembly | Click here | |
| The estimated course lines stop moving before the steering wheel is fully turned to the right or left | Steering angle setting (calibration) | Click here |
| The vehicle width extension guide lines and estimated course lines do not match when the steering wheel is turned to the center position | Check the installation of steering wheel | Click here |
| Correct the steering angle neutral point (initialization) | Click here | |
| Steering angle setting (calibration) | Click here | |
| Check that the rear television camera assembly is correctly installed | Click here | |
| Back camera position setting (calibration) | Click here | |
| Rear television camera assembly | Click here | |
| Spiral with sensor cable sub-assembly | Click here | |
| The guide lines are doubled up | Rear television camera assembly | Click here |
| Multi-media Module Receiver Assembly | Click here | |
| The guide lines are not displayed even though the luggage compartment door is closed | Check that the back door light assembly illuminates normally (if not, refer to Lighting System (EXT) - Problem Symptoms Table) | Click here |
| Rear television camera assembly | Click here | |
| The guide lines remain displayed even though the luggage compartment door is open | Check that the back door light assembly illuminates normally (if not, refer to Lighting System (EXT) - Problem Symptoms Table) | Click here |
| Rear television camera assembly | Click here | |
| When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the luggage compartment door has been closed | Check that the back door light assembly illuminates normally (if not, refer to Lighting System (EXT) - Problem Symptoms Table) | Click here |
| Rear television camera assembly | Click here | |
| "Back Camera Guide Line Setting" screen is not displayed | Rear television camera assembly | Click here |
| Multi-media Module Receiver Assembly | Click here | |
| "CHK" message(s) are displayed on the signal check screen | Signal check (diagnosis system) | Click here |
| When an image of the area behind the vehicle is displayed, the lines are misaligned (the image from the camera is tilted) | Back camera position setting (calibration) | Click here |
| Rear television camera assembly | Click here |