Back Door Glass (For Double Swing Out Type) Removal

Detach the 2 claws and remove the spare wheel carrier hinge bracket.

Remove the 2 nuts.

Detach the clip and remove the spare wheel cover.

Remove the 3 bolts and spare tire.

Remove the 9 bolts and spare wheel carrier.

Using a screwdriver, detach the 2 claws and open the 2 covers.

HINT:

Tape the screwdriver tip before use.

Remove the 2 bolts and assist grip.

Detach the claw and open the cover.

Remove the screw.

Using a screwdriver, detach the 2 claws.

HINT:

Tape the screwdriver tip before use.

Detach the guide and remove the door inside handle bezel in the direction indicated by the arrow in the illustration.

Detach the 10 clips and remove the back door trim panel.

Using a screwdriver, detach the 2 claws and open the 2 covers.

HINT:

Tape the screwdriver tip before use.

Remove the 2 bolts and assist grip.

Detach the 5 clips and 2 claws.

Detach the clamp and 2 claws and remove the back door trim cover.

Detach the 13 clips and remove the back door trim panel.

Open the wiper arm head cap.

Remove the nut and remove the rear wiper arm and blade assembly.

Detach the 5 clips and remove the back door center weatherstrip.

Apply protective tape to the outer surface of the vehicle body to prevent scratches.

NOTICE:

When separating the back door glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.

Disconnect the connectors.

Place matchmarks on the glass and vehicle body at the locations indicated in the illustration.

HINT:

Matchmarks do not need to be placed if the glass is not going to be reused.

From the interior, insert a piano wire between the vehicle body and back door glass as shown in the illustration.

NOTICE:

Make sure not to damage the wire harness.

Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

Cut through the adhesive by pulling the piano wire around the back door glass.

NOTICE:

Leave as much adhesive on the vehicle body as possible when removing the back door glass.

Using suction cups, remove the back door glass.

Apply protective tape to the outer surface of the vehicle body to prevent scratches.

NOTICE:

When separating the back door glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.

Disconnect the connectors.

Place matchmarks on the glass and vehicle body at the locations indicated in the illustration.

HINT:

Matchmarks do not need to be placed if the glass is not going to be reused.

From the interior, insert a piano wire between the vehicle body and back door glass as shown in the illustration.

NOTICE:

Make sure not to damage the wire harness.

Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

Cut through the adhesive by pulling the piano wire around the back door glass.

NOTICE:

Leave as much adhesive on the vehicle body as possible when removing the back door glass.

Using suction cups, remove the back door glass.

Clean and shape the contact surface of the vehicle body.

1. On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
   

   NOTICE:

   Be careful not to damage the vehicle body.

   HINT:

   Leave as much adhesive on the vehicle body as possible.

   Text in Illustration

   *1	Adhesive
   *2	Vehicle Body