Dtc C1268 Transfer L4 Position Switch Circuit

Brake. Land Cruiser. Urj200, 202 Grj200 Vdj200
Brake Control Dynamic Control Systems. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

INSPECTION PROCEDURE

INSPECT TRANSFER L4 SHIFT

RECONFIRM DTC

DTC C1268 Transfer L4 Position Switch Circuit


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
C1268
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN communication for 2 seconds or more.
  1. Transfer system
  1. Skid control ECU (Master cylinder solenoid)

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).
1.INSPECT TRANSFER L4 SHIFT

  1. Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

    OK:
    There are no problems with the transfer system.


NG
GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)
OK


2.RECONFIRM DTC

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Shift the transfer to L4, drive the vehicle, and then check for DTCs (Click here).

    Result
    Result
    		Proceed to
    DTC is not output
    		A
    DTC is output (for LHD)
    		B
    DTC is output (for RHD)
    		C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)