Rear Seat Entertainment System Display Mode Signal Circuit Between Multi-Display Controller And Television Display Assembly

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Audio Video. Land Cruiser. Urj200, 202 Grj200 Vdj200

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH)

REAR SEAT ENTERTAINMENT SYSTEM - Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly


DESCRIPTION

This is the display mode signal circuit between the multi-display controller sub-assembly and television display assembly RH.

WIRING DIAGRAM


Land Cruiser. Urj200, 202 Grj200 Vdj200.Audio Video.Audio And Visual System (For Radio Receiver Type).Rear Seat Entertainment System Display Mode Signal Circuit Between Multi-Display Controller And Television Display Assembly


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH)

  1. Disconnect the L67 multi-display controller sub-assembly connector.

  1. Disconnect the c38 television display assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    L67-9 (MDO) - c38-1 (MDO)
    		Always
    		Below 1 Ω
    L67-9 (MDO) - Body ground
    		Always
    		10 kΩ or higher


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)