Multi-Terrain Monitor System Data List / Active Test

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. DATA LIST

Multi-Terrain Monitor System -- Data List / Active Test



DATA LIST
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Chassis / Intelligent Parking Assist System / Back Guide Monitor / Data List.

  5. According to the display on the GTS, read the Data List.

    Intelligent Parking Assist System / Back Guide Monitor
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    AVC-LAN Master Connect Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Master Reset Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Connect Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Sending Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Regist Complete Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Regist Request Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    VGRS With or Without Status (Back Camera)
    		Displays "Parking Assist ECU's internal data may or may not match the "with/without VGRS" data that has been input" / OK or NG
    		OK: Data verification normal
    NG: Data verification abnormal
    		-
    ROM/SUM Check
    		Parking assist ECU information / OK or NG
    		OK: Parking assist ECU is normal
    NG: Parking assist ECU is abnormal
    		-
    EEPROM Status (Initial read)
    		Parking assist ECU information / OK or NG
    		OK: Parking assist ECU is normal
    NG: Parking assist ECU is abnormal
    		-
    RAM Check
    		Parking assist ECU information / OK or NG
    		OK: Parking assist ECU is normal
    NG: Parking assist ECU is abnormal
    		-
    IG Voltage Low Status
    		IG voltage input to parking assist ECU / OK or NG
    		OK: IG voltage is normal
    NG: IG voltage is abnormal (too low)
    		-
    IG Voltage High Status
    		IG voltage input to parking assist ECU / OK or NG
    		OK: IG voltage is normal
    NG: IG voltage is abnormal (too high)
    		-
    ACC Voltage Low Status
    		ACC voltage input to parking assist ECU / OK or NG
    		OK: ACC voltage is normal
    NG: ACC voltage is abnormal (too low)
    		-
    ACC Voltage High Status
    		ACC voltage input to parking assist ECU / OK or NG
    		OK: ACC voltage is normal
    NG: ACC voltage is abnormal (too high)
    		-
    CPU Communication Status
    		Continuous bus off / Not detected or detected
    		Not detected: Communication condition available
    Detected: Communication condition not available
    		-
    VGRS Relative Angle Status
    		Displays "VGRS may be active or inactive" / OK or NG
    		OK: VGRS normal
    NG: VGRS abnormal
    		-
    Wheel Speed Sensor (4wheel)
    		Effectivity of speed signal from speed signal sensor / OK or NG
    		OK: Speed signal is effective
    NG: Speed signal is not effective
    		-
    Wheel Speed Sensor (Front)
    		Effectivity of speed signal from speed signal sensor / OK or NG
    		OK: Speed signal is effective
    NG: Speed signal is not effective
    		-
    G Sensor Status
    		Effectivity of speed signal from G sensor / OK or NG
    		OK: Speed signal is effective
    NG: Speed signal is not effective
    		-
    AVC-LAN Output ON Resp
    		AVC-LAN communication condition / OK or Timeout
    		OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    		-
    AVC-LAN Output OFF Resp
    		AVC-LAN communication condition / OK or Timeout
    		OK: AVC-LAN communication condition normal
    Timeout: AVC-LAN communication condition abnormal
    		-
    Continuous Bus Off
    		Continuous bus off / Not detected or detected
    		Not detected: Communication condition available
    Detected: Communication condition not available
    		-
    Sending CAN Message
    		Communication condition from parking assist ECU / OK or NG
    		OK: Communication condition available
    NG: Communication condition not available
    		-
    ACC Terminal
    		ACC power supply voltage value / 0 to 5 V
    		Engine switch on (ACC) approximately 5 V
    		-
    IG Terminal
    		IG power supply voltage value / 0 to 5 V
    		Engine switch on (IG) approximately 5 V
    		-
    Camera Select SW Terminal
    		Camera select switch terminal voltage / 0 to 5 V
    		Camera select switch on approximately 5 V
    		-
    Rev Terminal
    		Reverse signal power supply voltage value / 0 to 5 V
    		Shift lever in R approximately 5 V
    		-
    APGS Select SW Terminal
    		Parking assist pre support switch signal value / 0 to 5V
    		Parking assist pre support switch on: Below 1 V
    Parking assist pre support switch off: Approx. 5
    		-
    Mirror Storage Signal
    		Status of the mirror storage signal / NG or OK
    		OK: Status of the mirror storage signal is normal
    NG: Status of the mirror storage signal is abnormal
    		-
    Back Door Courtesy Signal
    		Back door courtesy switch signal / ON or OFF
    		ON: Back door open
    OFF: Back door closed
    		-
    Vehicle Information Check (Back Camera)
    		Status of the vehicle information Check (rear camera) / OK or NG
    		OK: Collation result normally
    NG: Collation result abnormally
    		-
    Number of DTC
    		Number of stored trouble codes / min.: 0, max.: 255
    		Number of DTCs will be displayed
    		-
    Back Camera Synchronization Malfunction Key Cycle
    		Cumulative number of times the engine switch was turned on (IG) before the back camera synchronization malfunction occurred / min.: 0, max.: 65535 times
    		Cumulative number of times the engine switch was turned on (IG) before the back camera synchronization malfunction occurred will be displayed
    		-
    Back Camera Synchronization Malfunction Key Cycle Elapsed Time
    		Time elapsed since the power switch was turned on (IG) before the back camera synchronization malfunction occurred / min.: 0, max.: 1677721.5 seconds
    		Time elapsed since the engine switch was turned on (IG) before the back camera synchronization malfunction occurred will be displayed
    		-
    Front Camera Synchronization Malfunction Key Cycle
    		Cumulative number of times the engine switch was turned on (IG) before the front camera synchronization malfunction occurred / min.: 0, max.: 65535 times
    		Cumulative number of times the engine switch was turned on (IG) before the front camera synchronization malfunction occurred will be displayed
    		-
    Front Camera Synchronization Malfunction Key Cycle Elapsed Time
    		Time elapsed since the power switch was turned on (IG) before the front camera synchronization malfunction occurred / min.: 0, max.: 1677721.5 seconds
    		Time elapsed since the engine switch was turned on (IG) before the front camera synchronization malfunction occurred will be displayed
    		-
    Driver Side Camera Synchronization Malfunction Key Cycle
    		Cumulative number of times the engine switch was turned on (IG) before the driver side camera synchronization malfunction occurred / min.: 0, max.: 65535 times
    		Cumulative number of times the engine switch was turned on (IG) before the driver side camera synchronization malfunction occurred will be displayed
    		-
    Driver Side Camera Synchronization Malfunction Key Cycle Elapsed Time
    		Time elapsed since the power switch was turned on (IG) before the driver side camera synchronization malfunction occurred / min.: 0, max.: 1677721.5 seconds
    		Time elapsed since the engine switch was turned on (IG) before the driver side camera synchronization malfunction occurred will be displayed
    		-
    Passenger Side Camera Synchronization Malfunction Key Cycle
    		Cumulative number of times the engine switch was turned on (IG) before the front passenger side camera synchronization malfunction occurred / min.: 0, max.: 65535 times
    		Cumulative number of times the engine switch was turned on (IG) before the front passenger side camera synchronization malfunction occurred will be displayed
    		-
    Passenger Side Camera Synchronization Malf Key Cycle Elapsed Time
    		Time elapsed since the power switch was turned on (IG) before the front passenger side camera synchronization malfunction occurred / min.: 0, max.: 1677721.5 seconds
    		Time elapsed since the engine switch was turned on (IG) before the front passenger side camera synchronization malfunction occurred will be displayed
    		-
    Vehicle Information Check (Side Camera LH)
    		Status of the vehicle information Check (side camera LH) / OK or NG
    		OK: OK: Collation result normally
    NG: Collation result abnormally
    		-
    Vehicle Information Check (Front Camera)
    		Status of the vehicle information Check (front camera) / OK or NG
    		OK: Collation result normally
    NG: Collation result abnormally
    		-
    Vehicle Information Check (Side Camera RH)
    		Status of the vehicle information Check (side camera RH) / OK or NG
    		OK: Collation result normally
    NG: Collation result abnormally
    		-
    Current Key Cycle
    		Cumulative number of times the engine switch was turned on (IG) / min.: 0, max.: 65535 times
    		Cumulative number of times the engine switch was turned on (IG) before will be displayed
    		-
    Current Key Cycle Elapsed Time
    		Time elapsed since the engine switch was turned on (IG) / min.: 0, max.: 1677721.5 seconds
    		Time elapsed since the engine switch was turned on (IG) before will be displayed
    		-