Parking Assist Monitor System (W/ Side Monitor System) Data List / Active Test

Audio Visual Telematics. Land Cruiser. Urj200, 202 Grj200 Vdj200
Park Assist Monitoring. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. DATA LIST

Parking Assist Monitor System (W/ Side Monitor System) -- Data List / Active Test



DATA LIST
HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Parking Assist Monitor System / Data List.

  5. Enter the following menus: Body / Main body / Data List.

  6. According to the display on the tester, read the Data List.

    Parking Assist Monitor System
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    AVC-LAN Master Reset Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Master Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Connect Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Sending Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Regist Complete Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    AVC-LAN Regist Request Status
    		AVC-LAN communication condition / OK or NG
    		OK: AVC-LAN communication condition is normal
    NG: AVC-LAN communication condition is abnormal
    		-
    VGRS With or Without Status
    		Displays "Parking Assist ECU's internal data may or may not match the "with/without VGRS" data that has been input" / OK or NG.
    		OK: Data Verification Normal
    NG: Data Verification Abnormal
    		-
    Destination Data Check
    		Verification of Destination Data / OK or NG
    		OK: Data Verification Normal
    NG: Data Verification Abnormal
    		-
    EEPROM Status (Initial read)
    		Parking assist ECU information / OK or NG
    		OK: Parking assist ECU is normal
    NG: Parking assist ECU is abnormal
    		-
    IG Voltage Low Status
    		IG voltage input to parking assist ECU / OK or NG
    		OK: IG voltage is normal
    NG: IG voltage is abnormal (too low)
    		-
    IG Voltage High Status
    		IG voltage input to parking assist ECU / OK or NG
    		OK: IG voltage is normal
    NG: IG voltage is abnormal (too high)
    		-
    ACC Voltage Low Status
    		ACC voltage input to parking assist ECU / OK or NG
    		OK: ACC voltage is normal
    NG: ACC voltage is abnormal (too low)
    		-
    ACC Voltage High Status
    		ACC voltage input to parking assist ECU / OK or NG
    		OK: ACC voltage is normal
    NG: ACC voltage is abnormal (too high)
    		-
    AISIC Output Status
    		Output condition of camera display signal / OK or NG
    		OK: Output condition of camera display signal is normal
    NG: Output condition of camera display signal is abnormal
    		If displayed "NG", There is a malfunctions in parking assist ECU.
    VGRS Relative Angle Status
    		Displays "VGRS may be active or inactive" / OK or NG
    		OK: VGRS normal
    NG: VGRS abnormal
    		-
    Wheel Speed Sensor (4wheel)
    		Effectivity of speed signal from speed signal sensor / OK or NG
    		OK: Speed signal is effective
    NG: Speed signal is not effective
    		-
    Number of DTC
    		Number of stored trouble codes / min.: 0, max.: 255
    		Number of DTCs will be displayed
    		-

    Main Body
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Back Door Courtesy SW
    		Back door courtesy light switch signal / ON or OFF
    		ON: Back door open
    OFF: Back door closed
    		-