Relay (W/ Headlight Cleaner System) On-Vehicle Inspection

w/o Washer Linked Operation:

1. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Condition	Specified Condition
   6 (B) - 4 (E)	Battery voltage is not applied between terminals 3 (IG) and 2 (H)	10 kΩ or higher
   	Battery voltage is applied between terminals 3 (IG) and 2 (H)	Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)

   If the result is not as specified, replace the headlight cleaner control relay.
   

   Text in Illustration

   *a	Component without harness connected (Headlight Cleaner Control Relay)

w/ Washer Linked Operation:

1. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Condition	Specified Condition
   6 (B) - 4 (E)	Battery voltage not applied	10 kΩ or higher
   	Battery positive (+) → Terminal 3 (IG) Battery negative (-) → Terminal 4 (E) Battery negative (-) → Terminal 5 (FRWA)
   	Battery positive (+) → Terminal 3 (IG) Battery positive (+) → Terminal 2 (H) Battery negative (-) → Terminal 4 (E)	Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
   	Battery positive (+) → Terminal 3 (IG) Battery positive (+) → Terminal 1 (HDLO) Battery negative (-) → Terminal 4 (E) Battery negative (-) → Terminal 5 (FRWA)

   If the result is not as specified, replace the headlight cleaner control relay.
   

   Text in Illustration

   *a	Component without harness connected (Headlight Cleaner Control Relay)