Dynamic Radar Cruise Control System Distance Control Ecu Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
INSPECT FUSE (ECU-IG No. 3)
CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - BATTERY AND BODY GROUND)
DYNAMIC RADAR CRUISE CONTROL SYSTEM - Distance Control ECU Power Source Circuit |
DESCRIPTION
This circuit provides power to operate the distance control ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
| 1.INSPECT FUSE (ECU-IG No. 3) |
Remove the ECU-IG No. 3 fuse from the cowl side junction block RH.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
ECU-IG No. 3 fuse
| Always
| Below 1 Ω
|
| 2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - BATTERY AND BODY GROUND) |
Disconnect the E108 distance control ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Switch Condition
| Specified Condition
|
E108-1 (B) - Body ground
| Engine switch on (IG)
| 11 to 14 V
|
Engine switch off
| Below 1 V
|
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E108-12 (GND) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
|
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here) |
|
