Lumbar Switch (For Manual Seat) Removal
Seat. Land Cruiser. Urj200, 202 Grj200 Vdj200
REMOVE FRONT SEAT ASSEMBLY LH
REMOVE VERTICAL ADJUSTER COVER LH (for 8 Way Seat Type)
REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat Type)
REMOVE VERTICAL SEAT ADJUSTER KNOB (for 8 Way Seat Type)
REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
REMOVE FRONT SEAT CUSHION SHIELD LH
REMOVE LUMBAR SWITCH (w/ Lumbar Support)
Lumbar Switch (For Manual Seat) -- Removal |
- CAUTION:
- Wear protective gloves. Sharp areas on the parts may injure your hands.
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat assembly (Click here).
| 2. REMOVE VERTICAL ADJUSTER COVER LH (for 8 Way Seat Type) |
Using a screwdriver, detach the 2 claws and remove the vertical adjuster cover LH.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE VERTICAL ADJUSTING HANDLE LH (for 8 Way Seat Type) |
Remove the 2 screws and vertical adjusting handle LH.
| 4. REMOVE VERTICAL SEAT ADJUSTER KNOB (for 8 Way Seat Type) |
Remove the snap ring and vertical seat adjuster knob.
| 5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH |
Lift the reclining adjuster release handle LH.
Using a screwdriver, detach the claw and remove the reclining adjuster release handle LH.
- HINT:
- Tape the screwdriver tip before use.
| 6. REMOVE FRONT SEAT CUSHION SHIELD LH |
w/ Seatback Board:
Disconnect the 2 rubber bands from the 2 hooks.
w/o Seatback Board:
Disconnect the rubber band from the 2 hooks.
for 4 Way Seat Type:
Remove the 2 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield LH.
for 8 Way Seat Type:
Remove the 3 screws.
Detach the 3 claws in the order shown in the illustration, and then remove the front seat cushion shield LH.
w/ Lumbar Support:
Disconnect the lumbar switch connector.
| 7. REMOVE LUMBAR SWITCH (w/ Lumbar Support) |
Remove the 2 screws and switch.
