Back Door Garnish (W/ Tire Carrier) Installation

Clean the vehicle body surface.

1. Using a heat light, heat the vehicle body surface.
   

2. Remove the double-sided tape from the vehicle body.
   

3. Wipe off any tape adhesive residue with cleaner.
   

Install a new rear license light cover.

1. Using a heat light, heat the vehicle body and a new rear license light cover.
   

2. Remove the peeling paper from the face of the emblem.
   

   HINT:

   After removing the peeling paper, keep the exposed adhesive free from foreign matter.

3. Attach the 7 claws to install the rear license light cover.
   

   HINT:

   Press the rear license light cover firmly to install it.

Install the 2 license plate lights with the 2 screws.

Pass the wire harness of the license plate light through the tail gate, and install the wire harness.

Attach the 8 clips to install the No. 2 back door outside garnish sub-assembly.

Install the 2 nuts and connect the connector.

Attach the 16 clips to install the back door trim panel assembly.

Install the 4 bolts.

Install the back door trim cover RH as shown in the illustration.

Install the back door trim cover LH as shown in the illustration.

Attach the 6 clips to install the rear floor mat support plate.

Attach the 6 clips to install the back door outside garnish sub-assembly.