Drivetrain. Land Cruiser. Urj200, 202 Grj200 Vdj200
REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
REMOVE FRONT WHEEL
DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
REMOVE FRONT DISC
REMOVE FRONT AXLE HUB GREASE CAP LH
REMOVE FRONT AXLE SHAFT NUT LH
REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
Front Axle Hub -- Removal |
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
| 1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS) |
Detach the clamp, and disconnect the connector from the protector.
Remove the 3 bolts and protector.
| 2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS) |
Using a 5 mm hexagon socket wrench, loosen the lower and upper chamber shutter valves of the stabilizer control with accumulator housing 2.0 to 3.5 turns.
- NOTICE:
- When loosening a shutter valve, make sure that the end protrudes 2 to 3.5 mm (0.0787 to 0.137 in.) from the surface of the block, and do not turn the shutter valve any further.
- Do not remove the shutter valves.
| 4. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH |
Remove the bolt and nut, and disconnect the brake tube bracket from the steering knuckle.
Remove the 2 bolts and disconnect the disc brake caliper from the steering knuckle.
- NOTICE:
- Do not disconnect the flexible hose from the disc brake caliper.
- Do not twist or bend the flexible hose.
| 6. REMOVE FRONT AXLE HUB GREASE CAP LH |
Using a screwdriver and hammer, remove the axle hub grease cap.
- NOTICE:
- Do not damage the axle hub.
| 7. REMOVE FRONT AXLE SHAFT NUT LH |
Remove the cotter pin and adjusting lock cap.
Using a 39 mm socket wrench, remove the axle hub nut.
| 8. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH |
Remove the 4 bolts.
Using SST, remove the front axle hub together with the dust cover.
- SST
- 09950-40011(09951-04020,09952-04010,09953-04020,09954-04010,09955-04061,09957-04010,09958-04011)
Remove the O-ring.
