Height Control Sensor (For Front Side) Installation

Suspension. Land Cruiser. Urj200, 202 Grj200 Vdj200
Suspension Control. Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

  2. INSTALL FRONT WHEEL

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

  5. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

  6. INSTALL FRONT FENDER APRON TRIM PACKING B

  7. PERFORM ZERO POINT CALIBRATION OF G SENSOR

  8. ADJUST HEADLIGHT ASSEMBLY

Height Control Sensor (For Front Side) -- Installation


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Install the sensor with the bolt and nut.

    Torque:
    for bolt:
    13 N*m{127 kgf*cm, 9 ft.*lbf}
    for nut:
    5.6 N*m{57 kgf*cm, 50 in.*lbf}

  1. Connect the connector.



2. INSTALL FRONT WHEEL
Torque:
for Aluminum Wheel:
131 N*m{1336 kgf*cm, 97 ft.*lbf}
for Steel Wheel:
209 N*m{2131 kgf*cm, 154 ft.*lbf}


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

  1. Perform the vehicle height offset calibration (Click here).



5. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY
NOTICE:
  1. Make adjustments from the link that deviates the most from the specified vehicle height value.
  2. When the front and rear are at the same level, make adjustments from the front first.
  3. If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.


    Land Cruiser. Urj200, 202 Grj200 Vdj200

  1. Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.

    HINT:
    When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

  1. Tighten the nut of the height control sensor link.

    Torque:
    5.6 N*m{57 kgf*cm, 50 in.*lbf}


6. INSTALL FRONT FENDER APRON TRIM PACKING B

  1. w/ KDSS:
    Install the front fender apron trim packing B with the 3 clips.

  1. w/o KDSS:
    Install the front fender apron trim packing B with the 4 clips.



7. PERFORM ZERO POINT CALIBRATION OF G SENSOR

  1. Perform the zero point calibration of G sensor (Click here).



8. ADJUST HEADLIGHT ASSEMBLY

  1. for Halogen Headlight and LED Headlight:
    (Click here)